A HERNIA ON A WHEEL: IS IT POSSIBLE TO RIDE AND HOW TO REMOVE IT

Send

The appearance of a hernia, fungus, lamb on the tire, she is a ghoul, is not the most pleasant phenomenon. As a rule, many drivers immediately rush to change the tire, but in the worst case, you have to change two tires at the same time, so that on one axle they are the same. It's one thing if you have a domestic car and it won't hit your pocket hard to put on shoes. Another thing is to put shoes on a foreign car, and even in foreign-made rubber.

Depending on the size of the hernia on the car tire, it is worth considering further actions and, of course, the cost of waste. A small mushroom, 1-2 centimeters in diameter, is not very scary, you can still ride, but you should not delay repairs. In the case when a hernia is the size of a fist, it is fraught with a tire rupture and a possible accident, if the speed is not observed.

Why did the wheel hernia appear?

It is impossible to say unequivocally the reason why a hernia has formed on a car tire, because the structure of the tire itself is very complex. During the existence and production of automobile tires, experts have identified several main reasons. Marking on car tires is usually of little interest to anyone, most often they look at the size and relation to the season (winter, summer or all-season). Few people know that the letter R, in front of the diameter, most often means the presence of a radical cord, if there is no such marking, then the cord of such a tire is diagonal. The cord is also divided according to the material of manufacture, metal or polymer.

The main reason for the appearance of a hernia on a car tire is considered to be the rupture of threads in the structure of the tire. As a rule, this happens due to large overloads, incorrect pressure, or even lightning damage (a sharp hit on a curb, falling into a hole or other situations). It is possible that the appearance of a hernia on the wheel can be caused by poor quality tires, improper use of tires, or driving on a previously damaged tire. Nevertheless, in most cases, the appearance of such a reason is associated with the careless use of tires.

Is the appearance of a hernia on the tire dangerous and is it possible to ride?

A hernia on a car tire looks unattractive, but it also carries a certain danger. Worst of all, it could be a tire rupture with further accidents. It is good if the car drives slowly and the driver can react in time, and imagine the situation on a loaded minivan or heavy SUV. As a rule, it is very difficult or impossible to drive such a car with a broken tire.

Nobody canceled the laws of physics, and you shouldn't forget about them either. The more loaded the car and the more bumps on the road, the more chances of a hernia on the tire. The worst can be a shoulder hernia located on the scar between the tread and the side of the tire. In addition to weakening the cord at this point, the tread at this point wears out very quickly. It is highly discouraged to operate a car with such a tire, the maximum is to get to the nearest service station or home, but even then at a low speed. The most common situation can be the unlacing of the court, as a result of which the tire is divided into separate parts, despite the fact that it looks like one piece.

If purely hypothetically, then you can ride with a hernia on a car wheel. To do this, you need to systematically examine the damaged area for the appearance of new breaks, an increase in the size of the defect. At the same time, one should not forget about the basic rules in such a situation:

driving at high speed is contraindicated, especially if the road surface is uneven or very winding. The slightest hole can rupture the tire.
minimizing the load on the tires. It is not recommended to carry a heavy load or any other load that can also cause the tire to burst.
Many drivers recommend rearranging the hernia tire. Thanks to this approach, if the tire does burst, the driver will be able to maintain control of the car, which cannot be said about the failure of the front axle.

Conclusion - you can ride a tire with a hernia, in the case when you need to get to a certain point on the road, go home, or just move around. Still, do not delay replacing the tire with a new one, otherwise the car will let you down at the most inopportune time.

Can a wheel hernia be removed or repaired?

Whether or not a wheel hernia can be removed is a moot point. Rather, it all depends on the situation and the degree of damage, as well as on the very structure of the car tire. To begin with, consider a situation when a hernia appeared on the road, and there is no way to change a wheel or a spare tire. The first thing to do is to move the damaged wheel to the rear axle, thereby ensuring the car's handling. Do not forget about the speed of movement, it should be minimal, especially on uneven roads. Periodically, you need to stop and examine the hernia, an increase in size. If possible, unload the damaged axle of the vehicle by evenly distributing the load.

Now let's consider the situation with how to "cure" a hernia on a car wheel. Today there are many ways, from home to professional at the service station. It makes no sense to talk about how the repair works at the service station, the technology is progressing quickly, the material changes, plus everything needs tools. Most often, the cost of repairs is equal to an inexpensive tire. Much more interesting is the repair of a hernia of a wheel at home.

First you need to disassemble the wheel and separate the tire from the disc, thereby gaining free access to the problem area. Further, on the inside, it is necessary to glue a reinforcing patch, which does not just consist of rubber, but in addition has reinforcing properties. The size of the patch should be larger than the damaged area, even with a small margin, lie on the whole surface.

Next, on top of the patch, it is worth sticking a piece of rubber previously cut from the camera. This will reduce pressure on the hernia and increase the strength of the patch. A huge disadvantage is the imbalance of the wheel, which will often need to be balanced in the future. Finally, from the outside, the damaged area can be pulled together with strong nylon threads. This whole procedure is completed by an additional layer of regular or liquid rubber, laid on top of the threads. Thus, you will gain additional strength and minimize the recurrence of hernia on the car wheel.